I’m building an experimental O-200. I’m probably reading it wrong, but what takes precedence - the 2011 overhaul manual or the 2019 M-O manual?

Specifically in the area of threading the case.

OH says permatex and string on the 2-4 case half. Nothing on the bearing bosses except for the #7 stud below the rear cam bearing.

M-O says permatex and thread around all main bearing bolt holes as well PLUS Loctite 515 on the 1-3 case halves opposite the permatex coated areas. HOWEVER the M-O diagram is for ALL 4 cylinder engines without breakouts for each model.

In the sealants table (3-4) it says use the 515 on all SI models. The SIL 99C-2 has same table, but instead of “all SI models” says “as appropriate.”

I’m leaning to follow the OH since it is specific to the O-200.

Am I correct? Thank You for sharing your wisdom.