Aircraft Dent Filler Question

[cjmartinflyers]

Hello. Can anyone recommend a type of body/dent filler that could be used on the leading edge of an aluminum wing to fill a small dent (1/4 inch diameter). I have seen the aircraft paint shops using some type of product but I am not sure what it was. I would think that the material would have to be flexible (unlike automotive Bondo) to cope with the flexing and expanding/contracting of the surface of the wing. Thank you.

[Kyle Boatright]

Hello. Can anyone recommend a type of body/dent filler that could be used on the leading edge of an aluminum wing to fill a small dent (1/4 inch diameter). I have seen the aircraft paint shops using some type of product but I am not sure what it was. I would think that the material would have to be flexible (unlike automotive Bondo) to cope with the flexing and expanding/contracting of the surface of the wing. Thank you.

People normally use filled epoxy for that kind of thing. West Epoxy plus microballoons, for instance. Alternately, another filled epoxy like superfil, which would be my choice if I didn't have a bunch of composite supplies laying around the shop.

https://www.aircraftspruce.com/catal...?clickkey=6925

In either case, you need to clean and scuff the area very well or the epoxy based filler may pop off one day.

[cjmartinflyers]

Hi Kyle. Thank you for your response. The superfil looks like just what I need and it is available in a small 20 container. Thanks again!

[Bill Berson]

Aircraft Paint shops use ordinary automotive bondo.