Results 1 to 10 of 10

Thread: NSI re-drive information

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    lin_light's Avatar
    Join Date
    Oct 2011
    Location
    Holland, Michigan
    Posts
    3

    NSI re-drive information

    I have a NSI re-drive on a Subaru EA81. I purchased it with a plane at an auction. The builder passed away in 2003 and I have no information on the ratio of the gear. The plane is about 1,000 to 1,200 lbs and is designed for 150 mph. Any way of judging the ratio? I have someone interested in purchasing the drive and want to know the ratio. Any information would be appreciated.

    Lin

  2. #2
    Mike Switzer's Avatar
    Join Date
    Jul 2011
    Location
    Central Illinois
    Posts
    979
    I don't know if it is a gear or belt drive, but pull the cover & count the teeth on the gears or pulleys, then figure the ratio - but most will have a tag or a stamp somewhere that shows the ratio.

    (That goes for a toothed belt drive, if it is a straight v belt drive it is a little more complicated, the critical drive diameters will be stamped on the pulleys (it is hard to measure accurately) & you use them to figure the ratios)
    Last edited by Mike Switzer; 10-24-2011 at 09:17 PM.

  3. #3
    lin_light's Avatar
    Join Date
    Oct 2011
    Location
    Holland, Michigan
    Posts
    3
    Gear driven. Think there is any issues opening up the case?

  4. #4
    Mike Switzer's Avatar
    Join Date
    Jul 2011
    Location
    Central Illinois
    Posts
    979
    Probably not, it is probably just 2 gears with 2 bearings on each gear shaft. Drain the oil into something first, there should be a drain plug & a fill plug, if you just split the case you will have a mess if it holds a lot of oil.

    Depending on the size you might want to get a full or half size aluminum sheet cake pan to set it on when you open it. (Half sheet pans are approx 12 x 18 & you can pick them up cheap at Sams, full are approx 24 x 18 & you will probably have to order them)

  5. #5
    Mike Switzer's Avatar
    Join Date
    Jul 2011
    Location
    Central Illinois
    Posts
    979
    Oh, another thing, there will be a seal where the shafts go thru the case, be careful not to damage them. Depending on their condition you may want to replace them anyway, they don't last forever & they are usually pretty cheap at the local bearing store / industrial power transmission supplier.

    A little Vaseline helps the new ones go on without damaging them
    Last edited by Mike Switzer; 10-25-2011 at 09:07 AM.

  6. #6
    lin_light's Avatar
    Join Date
    Oct 2011
    Location
    Holland, Michigan
    Posts
    3
    Drive has never been used. Still attacted to the Engine where it was attached around 1997. Have some interested in it and wanted to know the ratio.
    I'm guessing 2is to 1

    Lin

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •