Search:

Type: Posts; User: JoeT

Search: Search took 0.00 seconds.

  1. Sticky: Does the NEW SolidWorks for Makers include the...

    Does the NEW SolidWorks for Makers include the Simulation software - i.e., CFD and FEA? The previous version did include the SIMULATION package.

    Regards,
    Joe T.
  2. Replies
    0
    Views
    1,211

    SOLIDWORKS for Makers Question

    Does the NEW SolidWorks for Makers include the Simulation software - i.e., CFD and FEA? The previous version did include the SIMULATION package.

    Regards,
    Joe T.
  3. Sticky: This is going to be very helpful. As I am...

    This is going to be very helpful. As I am becoming more comfortable with Flow Wim, this will be my next challenge!

    I took 15 'WORKBENCHES' of CATIA V5 at the local university after I retired. ...
  4. Sticky: Thank you!! Regards, Joe T.

    Thank you!!

    Regards,
    Joe T.
  5. Torque vs. Moment

    With all due respect, here is a quick answer to this question (attachment 1). Please note the first comparison.

    The second attachment is from a RANS CFD tool I leased for a year. It is 'Stallion...
  6. Cory, you were close, but no cigar

    Everything worked until you stated "Recalculate." That didn't work.

    You can see the CG (Black and White 'BMW' Circle), the 'Local Coordinate System' (GREEN), and 'Coordinate System 1' (BLUE) in...
  7. It is where it is being applied that is the...

    It is where it is being applied that is the concern.

    Joe T.
  8. Cori, I've watched it several times. As...

    Cori,

    I've watched it several times. As stated in your post above, there is no audio. That's a real problem.

    Also, the video is very poor quality. I am not sure what menus. etc., were...
  9. I can't get the CG to 'Mate' to the re-located...

    I can't get the CG to 'Mate' to the re-located coordinate system. I get the following message:

    "Mating to the Center of Mass of the top level assembly is not allowed because it would create a...
  10. Cori/Steve, I'll try that. I was doing...

    Cori/Steve,

    I'll try that. I was doing something similar, but I could not get the CG to move to the new local coordinate axis. I'll try again.


    Also, Cori, I'll have you the parameters that...
  11. How to properly place the CG in Flow Simulation for moment calculations

    All,

    I want to be able to determine moments about my design's CG. How do I do that?

    When I have SW create a CG, it is not where I need it. Alternatively, how do I move the 'Local Coordinate...
Results 1 to 11 of 12