Having issues making an engine mount in SW.
Can't figure out how to run the tubes and make them mate correctly.
Type: Posts; User: rkirk77
Having issues making an engine mount in SW.
Can't figure out how to run the tubes and make them mate correctly.
Go here
https://www.solidworks.com/product/students
You can get it for $100 if you click on the "Solidworks Student Edition" on the left side of the bottom page.
I have a solution for you guys.
https://www.solidworks.com/product/students
You can get it for $100 if you click on the "Solidworks Student Edition" on the left side of the bottom page.
I have a solution for you guys.
https://www.solidworks.com/product/students
You can get it for $100 if you click on the "Solidworks Student Edition" on the left side of the bottom page.
Had the same issue and I am going to call them tomorrow to find out.
I did the same and am having the same issues.
I am going to call them tomorrow and ask what's going on.
Yes 4130 tubing.. forgot to put that in the post. lol
Any suggestion on a good tube bender for doing fuselage, stab parts.. etc.
I am still learning the basics of SW and eventually (.. within the next week) I am hoping to have it complete to print out.
PS, my plane is an experimental BC-12 that will have a few more features...
..and this.
86448644
8643UPDATE : I think I've got it.
I am trying to make this so I can print it out and layout my ribs.. any suggestions?
Hi Christian,
I have reviewed this / your previous post and have read them carefully, and know this is a VERY easy operation to someone like you but I am a blithering idiot when it comes to SW.
...
8640
I think I am having some difficulty with getting the airfoil to scale down so the airfoil has a 63" chord (..or 63% from what i am reading here).
I am trying to make it so I can make a layout for...
I've gone ahead and made my airfoil ( NACA 23012 ) but don't know how to bring it to proper scale.
Where can I pickup a kit to convert a J-3 with a C-65 to an electric powered aircraft?
I've seen that there are a few new aircraft with them built-in and wanted to see if I can do it with a cub.. so...
I recently bought plans for a Benson B-8M and am curious what powerplant I should use.
Also any other general info might be helpful!
That looks about the same size as my shop..lol
My issue is that I cannot flange the inside of the ellipse, however it will let me do it to the outside.
PS, I re-saved the file as STEP.
Hi Guys,
I am trying to make a bulkhead with two edge flanges, but Solidworks is keeping me from my sanity.
The material is .050" aluminum with 5/8" flanges on inner and outer edges.
**FILE...
Wouldn't a Gypsy Major work just as well?
They are pretty close in size except the width.
They just did one this month.. which is why I am asking around.
Such a beautiful airplane!
Where can I find a set of drawings for a Ryan ST-A?
I've looked high and low and haven't been successful in finding any.
6364
I just installed Solidworks 2016 (..thank you EAA!!) and I am totally lost on how to make parts in sheet metal.
I am use to Autodesk Inventor and Fusion so I have NO IDEA how you go about doing...
Hi Guys,
I've just begun building some wing ribs for my Pietenpol Air Camper. I have made a few already but was made aware that I have made a misstep in that I have not done the following:
1)...