Thanks, SOLD.
BOB
Type: Posts; User: BobMo
Thanks, SOLD.
BOB
Not correct number.
2607
Attached is a drawing of a internal fuel tank using gravity fuel feed. Drwg 'A' is acording to the plans. Should work fine as long as the vent doesn't get clogged.
Dwg 'B' is a tail dragger...
Thank for the tips. I had not found my digital level and I remembered the 56 5/16" = one degree for every one inch rise. Plus, I just wanted another way to double check my digital levels accuracy....
IF:
I level my inner and outer wings.
measurer 56 5/16" from the attach point/pivot out the bottom of the outer wing.
Raise the outer wing 4" at that point.
Will my wing have 4 degrees dihedral?
Just to update..I bought a carbide 10"x 60 blade and it worked great. Good for about 9" then the blade hit the aluminum on the upstroke in the rear. Still, it worked far better than my band saw on...
Thanks for the tips. I was hoping for something like "The ACME all purpose cutoff wheel" $9.95 at Harbor Freight. But, I guess if something better was available it would be on 'Hints for...
Has anyone found something new & improved to cut 1/4" aluminum plate.
I need to make several long, straight cuts. Thinking there has to be a better
way. Some titanium Carbide diamond blade for my...
Has anyone experimented with the Gurney Flap? Particularly, the addition of the angle with 1.5 percent of cord. This seems to be the recommended ratio. Would be interested in results for a wing...