Search:

Type: Posts; User: ahramin

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    680

    The steel itself would have had to be bright red...

    The steel itself would have had to be bright red to deform like that (>1450F). Although your mixture will have a large effect on EGT, your exhaust system should be able to deal with anything your...
  2. I had the same problem today trying to access the...

    I had the same problem today trying to access the webinar archive. "Please Wait" that never clears.
  3. Replies
    4
    Views
    1,077

    Thank you both.

    Thank you both.
  4. Replies
    4
    Views
    1,077

    Taxiing with Clecos

    Is it ok to put a bit of stress on something assembled with clecos? I was asked if it was ok to taxi an aircraft with the rear fuselage still mostly clecos and I don't have a clue if this can damage...
  5. Replies
    16
    Views
    3,300

    Mike if I understand correctly your son will get...

    Mike if I understand correctly your son will get his $5000 downpayment back from the loan company but is worried about getting the $5000 deposit back from the seller.

    Was the non-refundable...
  6. Replies
    7
    Views
    2,005

    Does this engine have dual independent ignition...

    Does this engine have dual independent ignition systems?

    Edit: Just found this, sounds reasonable:

    No, each cylinder has one spark plug and its own ignition coil that is controlled and powered...
  7. Thread: Lean of Peak

    by ahramin
    Replies
    4
    Views
    1,370

    Interesting question. The easy answer is that...

    Interesting question. The easy answer is that there is a lot more to running lean of peak than just running lean of peak. I don't know about the O-320-H2AD but my O-320-E2D ran fine at 25 LOP (lean...
  8. We are still giving Young Eagles flights but have...

    We are still giving Young Eagles flights but have asked each pilot to really think about their risk factors. Some of the older members and some members taking care of elderly family decided not to....
  9. Replies
    7
    Views
    2,007

    I think we'll start by directing cooling air to...

    I think we'll start by directing cooling air to the filter itself. If that isn't enough then we'll add the fins.
  10. Replies
    13
    Views
    2,904

    Thank you all. The belt manufacturer did not have...

    Thank you all. The belt manufacturer did not have anything to say other than check for condition. Many good points here and it's much appreciated.
  11. Replies
    7
    Views
    2,007

    Our oil filter adapter does not lend itself to...

    Our oil filter adapter does not lend itself to adding oil cooler lines but your suggestion led me here Eric, thank you.
    ...
  12. Replies
    13
    Views
    2,904

    Seat Belt Replacement After an Accident

    Does anyone know of a requirement to replace seat belts after an accident (for occupied seats).
  13. Replies
    7
    Views
    2,007

    Well now that I've reread that post it makes no...

    Well now that I've reread that post it makes no sense. We have no oil cooler, it should gave said remote oil filter.
  14. Replies
    7
    Views
    2,007

    O-200 Oil Cooling

    We have a Zenith CH 750 Cruzer with an O-200 and have been having many temperature problems. We're getting close to getting CHTs under control but our oil temperature is still in the 210-220F on...
  15. Replies
    2
    Views
    6,207

    Thank you. Turned out to be a bad EFIS ground.

    Thank you. Turned out to be a bad EFIS ground.
  16. Replies
    2
    Views
    6,207

    Sudden Increase in Oil Pressure

    After an oil change from W100 to W100 plus, the oil pressure on our O-375 jumped up. In cruise it's normally ~85 psi, now it's at 104. Both with an oil temperature of 190F. Assuming the oil pressure...
  17. Replies
    5
    Views
    2,022

    If you are in British Columbia you may want to...

    If you are in British Columbia you may want to join the BC General Aviation Association https://www.bcaviation.ca/

    Lots of STOL flyers there that can share their experiences in the Rockies.
    ...
  18. Replies
    11
    Views
    2,511

    Anything useful here? ...

    Anything useful here?

    https://en.m.wikipedia.org/wiki/Warner_Revolution_II
  19. Replies
    12
    Views
    3,186

    Puppies?

    Puppies?
  20. Replies
    12
    Views
    3,186

    I made a male mold from wood and coated it with...

    I made a male mold from wood and coated it with bondo and sanded it for smoothness, then heated an oversized thick plexiglass peice with a heat gun and pulled it into place wearing work gloves. Once...
  21. Replies
    16
    Views
    4,991

    Every oil change (4 months) I remove the bolts,...

    Every oil change (4 months) I remove the bolts, clean and lubricate with beeswax, and reinstall. This is the only way I know of getting an somewhat accurate preload on prop bolts.

    It would be nice...
  22. Replies
    16
    Views
    4,991

    Very interesting Marc. Thank you.

    Very interesting Marc. Thank you.
  23. Replies
    16
    Views
    4,991

    Nord-Lock Washers with Wooden Prop

    Can Nord-Lock washers be used for prop bolts on a wooden prop or must the bolts be lockwired?
  24. Replies
    3
    Views
    1,206

    Personally, I think most of these incidents stem...

    Personally, I think most of these incidents stem from fuel planning that consists of "I always fly full tanks".

    The other day our fuel pumps were down and an RV owner was dissapointed not to be...
  25. Replies
    21
    Views
    4,977

    We could spend quite a bit of time debating this...

    We could spend quite a bit of time debating this to no purpose so I'll concede right away that if we are talking about single engine GA aircraft under $250k, none are equipped with TCAS/ACAS. My...
Results 1 to 25 of 42
Page 1 of 2 1 2